Classification and characteristics of copper bar production process


Release time:

2024-05-23

Copper bars are widely used in our daily electricity consumption and various electrical connections

Copper bars are widely used in our daily electricity consumption and various electrical connections, and there are many specifications, which are suitable for all walks of life. According to different use requirements, copper bar manufacturers can also produce copper bars in different ways. There are many kinds, let's introduce the classification and characteristics of the copper bar production process by the editor below!

According to the production method, copper bars can be divided into rolling-sawing method, rolling-stretching method, profile rolling method, extrusion-stretching method, upward drawing or horizontal continuous casting-rolling-stretching method, etc. Let's learn about each process together!

1. rolling-sawing method

1. Process flow: The production flow of this process is as follows: ingot heating-hot rolling-milling surface-blanking-cold rolling-annealing-pickling-cold rolling-sawing-corner treatment-finishing and straightening-cutting and sizing-packaging and warehousing.

2. Process characteristics: The performance indexes of copper bars produced by this process can be well controlled, but there are problems of flash and chip pressing. The corners are not rounded, the smoothness of the surface is not good, the width tolerance is large, the high precision requirements cannot be met, and the production cost is high. Therefore, this production method is rarely used now.
Copper Bow
2.-up or horizontal continuous casting-rolling-drawing method

1. Process flow: The production flow of this process is upward or horizontal continuous casting-cold rolling-annealing-pickling-stretching-finishing and straightening-cutting and sizing-packaging-warehousing.

2. Process characteristics: This production method has simple process and low production cost. However, the performance index is poor compared with other processes, the specifications are limited, the efficiency is low and the production capacity is small.

3. rolling-drawing method

1, process flow: the production process of the process for ingot heating-hot rolling-milling-cold rolling-cutting-annealing-pickling-stretching-finishing straightening-cutting-packaging-storage.

2, process characteristics: the use of rolling-stretching method of copper production of its quality indicators can be well controlled, and the production cost is low, but the shear flash and tolerance is difficult to control.

4. profile rolling method

1. Process flow: The production flow of this process is iron mold red ingot-hot (warm) rolling-pickling-rough rolling profile-annealing-pickling-finishing profile-finishing straightening-cutting and sizing-packaging-warehousing.

2, process characteristics: the use of this process of production of copper row its performance indicators can be well controlled, rolling mill type roller, high production costs.

5. extrusion-stretching method

1. Process flow: The production process of this process is ingot heating-extrusion-stretching-annealing-pickling-stretching-finishing and straightening-cutting and sizing-packaging-warehousing.

2. Process characteristics: The copper bar produced by extrusion-stretching method can guarantee the bending performance of 180 °, so its quality indicators can be well controlled. Its process is simple, high efficiency, large capacity, but the production cost is relatively high.

Quote Immediately

Fill out the message form and leave your contact information. Our staff will contact you within 24 hours (weekdays)
%{tishi_zhanwei}%